Removal Of Inner Bowl; Removal Of Clutch Mechanism (Spline Drive / Spline Driven); Removal Of Pump Hood - Fisher & Paykel SMARTDRIVE PHASE 7 Service Manual

517790C
10.12

Removal of Inner Bowl

(a) Follow procedures for removal of Neck Ring. (Refer to Section 10.10).
(b) Follow procedures for removal of Agitator. (Refer to Section 10.11).
(c) Lift inner bowl upwards and clear of machine.
Note: If the inner bowl is tight on the shaft pressure may need to be placed on the top of
the shaft, while at the same time jiggling the inner bowl upwards.
Reassembly:
Refit in the reverse manner.
10.13 Removal of Clutch Mechanism (Spline Drive / Spline
Driven)
(a) Follow procedures for removal of Inner
Bowl. (Refer to Section 10.12).
(b) Remove the 3 screws securing the spline
driven to the inner bowl.
Reassembly:
Refit in the reverse manner. Ensure that the
screws are tightened sufficiently with out over
tightening.
10.14

Removal of Pump Hood

(a) Follow procedures for removal of Inner
Bowl. (Refer to Section 10.12).
(b) Remove the bolt securing the pump hood to
outer bowl.
Reassembly:
Refit in the reverse manner. Ensure that the
gasket is not pinched between the pump hood
and outer bowl.
50