Fisher & Paykel SMARTDRIVE PHASE 7 Service Manual page 42

517790C
220. ( ) EEPROM Model Map Not Programmed
11011100
Similar to fault code 60.
Primary Source: Motor Control Module
Action:
230. (11100110) EEPROM Value out of Range
Wrong version detected
Primary Source:
Action:
232. (11101000) COMMS Timeout 5 Sec
IW only problem, either the Display or Motor Control Module has not responded in time.
Primary Source:
Action:
Secondary Source: Motor Control Module fault.
Action:
233. (11101001) EEPROM Read Error
Problem reading the EEPROM data coming from the Motor Control Module.
Primary Source:
Action:
234. (11101010) Lid Lock Open Circuit
Check Harness to Lid Lock and connections at the Motor Control Module and lid lock ends.
Primary Source:
Action:
Secondary Source: Lid Lock has failed to be activated.
Action:
Tertiary Source:
Action:
235. (11101011) Lid Lock Short Circuit
Lid Lock fault, not activated when instructed to by the Motor Control Module.
Primary Source:
Action:
236. (11101100) Incompatible EEPROM Version
Failure to start and fault immediately displayed.
Primary Source:
Action:
237. (11101111) Temperature Sensor Error
The electronics have picked up a continuity problem, same as fault code 10 or 41.
Primary Source:
Action:
Secondary Source: Motor Control Module has failed to read the temperature. Check
Action:
Replace Motor Control Module
Motor Control Module is the wrong version.
Change Motor Control Module.
Display Module fault.
Replace Display Module.
Replace Motor Control Module.
Motor Control Module fault.
Replace Motor Control Module.
Connector to the harness, either end could be at fault.
Replace Harness.
Replace Lid Lock housing.
Motor Control Module has not responded to the Lid Lock being
activated.
Check the lid has a tang and is fitted correctly to activate the Lid
Lock. If this is all in order, the Motor Control Module must be at fault
and needs to be replaced.
Lid Lock mechanism has jammed or failed.
Check resistance across the connections. If out of specification,
replace the lid lock, (63Ω +/- 10% @ 20
Motor Control Module is the wrong version.
Replace Motor Control Module.
The sensor has failed either in the harness or connection to the
thermistor.
Replace the Thermistor (temperature sensor)
connections.
Replace Motor Control Module if connections look fine and the fault
still occurs.
42
o o
C (68 F)).