Chapter 3: Mount the Device
You can mount the P333T-PWR in a rack.
The P333T-PWR chassis fits in most standard 19-inch racks. It is 2U (3.5", 88 mm) high.
Before you Install the P333T-PWR in a Rack
Disconnect all cables from the unit before proceeding with the rack installation.
●
When installing the P333T-PWR in a rack, ensure that the equipment is positioned such
●
that it will not cause the rack to become unstable or tip over.
Ensure that the combination of equipment in the rack will not cause an overload or
●
overcurrent condition on the power strip being used and/or the customer's branch circuit.
The P333T-PWR units weigh a maximum of 15 pounds (6.8 kg). Be careful when installing
●
or removing the P333T-PWR product from the rack.
If a power strip is being used in the rack, ensure that it has a reliable earth connection. If
●
the P333T-PWR equipment will be plugged directly into a wall outlet, ensure that there is a
reliable ground connection at the outlet.
Ensure that the internal rack ambient temperature is within the operating specification
●
limits of the P333T-PWR.
Ventilation for the P333T-PWR is from side to side. Ensure that there is adequate space on
●
each side of the P333T-PWR equipment when installed in the rack to allow sufficient
airflow.
Place the P333T-PWR in the rack as follows:
1. Snap open the hinged ends of the unit's front panel to reveal the screw holes. Refer to
Figure 2
Figure 2: Closed hinged end
Figure notes:
1. Closed hinged end
and
Figure
3.
P333R
51
52
53
54
55
56
57
58
1
2
3
4
EXPANSION
SLOT
59
60
61
62
63
64
65
66
13
14
15
16
LNK
COL
Tx
Rx
FDX
FC
Hspd
FIV
1
5
6
7
8
9
10
11 12
17
18
19
20
21
22
23
24
ROUT
LAG
SYS
OPR PWR
LAG
1
2
3
13
14
15
LAG
LAG
4
5
6
7
8
9
10
11
12
16
17
18
19
20
21
22
23
24
Issue 1 September 2005
CONSOLE
17