Table 2-7. Removing Display Components - HP OmniBook 7100 Service Manual

Component
Display Bezel
Display Bracket, Left,
Right, or Top
Display Cable
Display Case
Display Latch
End Cap
Hinge
Icon PCA
Inverter PCA
LCD Module
HP OmniBook 7100

Table 2-7. Removing Display Components

Removal Procedures
Keyboard (page 2-8).
Heatsink (page 2-9).
Keyboard (page 2-8).
Heatsink (page 2-9).
Display (page 2-11).
LCD module (page 2-11).
Keyboard (page 2-8).
Heatsink (page 2-9).
Display (page 2-11).
LCD module (page 2-11).
Keyboard (page 2-8).
Heatsink (page 2-9).
Display (page 2-11).
LCD module (page 2-11).
Keyboard (page 2-8).
Heatsink (page 2-9).
Display (page 2-11).
LCD module (page 2-11).
Keyboard (page 2-8).
Heatsink (page 2-9).
Keyboard (page 2-8).
Heatsink (page 2-9).
Display (page 2-11).
Plug-in module (page 2-3).
Hard drive (page 2-5).
Keyboard (page 2-8).
Heatsink (page 2-9).
Display (page 2-11).
Top case (page 2-14).
Keyboard (page 2-8).
Heatsink (page 2-9).
See page 2-11.
Additional Steps (See figure on page 4-5)
Remove the bezel (page 2-11).
Reassembly Notes: Install the hinge end caps into
the case before attaching the bezel.
Reassembly Notes: Make sure the two-wire cable to
the inverter PCA is under the main display cable near
the hinge opening.
Reassembly Notes: Make sure the two-wire cable to
the inverter PCA is under the main display cable near
the hinge opening.
1. Press the middle of the top bracket away from the
latch until it unhooks from the case, then lift out the
bracket.
2. Turn the case so the latch is closest to you.
3. Use your thumb to push the latch away from you
until it rolls out of the case. This takes some force.
Reassembly Notes: Make sure the ends of the spring
point up when inserted into the case. Make sure the
latch locks in place.
1. Remove the bezel (page 2-11).
2. Lift out the end cap.
Reassembly Notes: The mark molded into the cap
should be vertical when the display is laying flat.
1. Remove the bezel (page 2-11).
2. Remove the four screws from the bottom corners of
the display brackets. Remove the hinges.
Reassembly Notes: Install each hinge so the brighter
half is attached to the display case.
Do not install the outer screw until the bezel is
attached.
Remove the two screws that hold the PCA.
1. Do not remove the display assembly, but remove
the bezel as described (page 2-11).
2. Unplug the two cables from the inverter PCA.
3. Remove the screw from the PCA and remove the
PCA.
Reassembly Notes: Make sure the insulator covers
the inverter PCA.
Removal and Replacement 2-21