HP OmniBook 7100 Service Manual page 70

Serial Port
Base I/O address
Infrared Port
Mode
Base I/O address
DMA channel
Front/Back
Parallel Port
Mode
Base I/O address
Interrupt
DMA channel
Audio
SB I/O address
WSS I/O address
AdLib I/O address
Interrupt
1st DMA channel
2nd DMA channel
MPU Device
MPU I/O address
Interrupt
Security Menu
User Password Is
Administrator Password Is
Set User Password
Set Administrator
Password
Boot
Resume
Undock
Hard Disk Drive Lock
Floppy Boot
Power Menu
Power Management Mode
Smart CPU Mode
Standby Time-out
HP OmniBook 7100
Sets how the serial port is configured by the BIOS (specified
or automatic).
Sets the I/O address and interrupt.
Sets how the infrared port is configured by the BIOS (specified
or automatic).
Sets the hardware to support SIR (Standard IR), ASK IR
(amplitude shift keyed IR), or FIR (Fast IR) infrared
communications. (Driver installation required.)
Sets the I/O address and interrupt.
For Fast IR mode, sets the DMA channel.
Sets which infrared port is active.
Sets how the parallel port is configured by the BIOS (specified
or automatic).
Sets the port to normal, bi-directional, EPP, or ECP.
Sets the I/O address.
Sets the interrupt.
For ECP mode, sets the DMA channel.
Sets how the audio system is configured by the BIOS
(specified or automatic).
Sets the Sound Blaster I/O address.
Sets the Windows Sound System I/O address.
Sets the AdLib synthesizer I/O address.
Sets the interrupt.
Sets the DMA channel for playback.
Sets the DMA channel for recording.
Sets how the MIDI capability (hardware wavetable) is
configured by the BIOS (specified or automatic).
Sets the MIDI I/O address.
Sets the interrupt.
Shows if a user password is set.
Shows if an administrator password is set.
Press ENTER to set, change, or clear user password.
Password length can be no longer than 8 characters, 0-9, A-Z.
Press ENTER to set, change, or clear administrator password.
This password protects BIOS Setup settings.
Sets whether a user password is required when the computer
boots.
If boot security is enabled, sets whether a user password is
required when resuming from a suspended state.
If boot security is enabled, sets whether a user password is
required when undocking the OmniBook.
If boot security is enabled, sets whether a password is stored
on the hard disk. Secures data on the disk if the disk is moved
to another computer.
Sets whether the floppy drive is a boot device.
Disables time-outs, selects a combination of time-outs, or
allows customized time-outs.
Enables automatic CPU power savings. Absence of keyboard,
mouse, and hard disk activity could cause slower CPU
response.
Sets the period of inactivity after which the computer goes
from On to Standby power mode.
Troubleshooting and Diagnostics
Enabled
3F8h, IRQ4
Disabled
SIR
2F8h, IRQ3
DMA3
Back
Enabled
ECP
378h
IRQ7
DMA3
Enabled
220h
530h
388h
IRQ5
DMA1
DMA0
Disabled
330h
IRQ11
Default
Clear
Clear
Enabled
Enabled
Disabled
Disabled
Enabled
Default
Max Power
Savings
Off
2 minutes
3-23