HP OmniBook 7100 Service Manual page 71

Suspend Time-out
Hibernate Time-out
Hard Disk Time-out
Time-out on AC
Power Button Mode
Resume on Modem Ring
Resume on Time of Day
Resume Time
Auto Suspend on Undock
Boot Menu
Diskette Drive
Hard Drive
CD-ROM Drive
Exit Menu
Save Changes and Exit
Discard Changes and Exit
Get Default Values
Load Previous Values
Save Changes
3-24 Troubleshooting and Diagnostics
Sets the period of inactivity after which the computer goes
from Standby to Suspend power mode. (Skips Standby mode
if that time-out is disabled.)
Sets whether the computer goes from Suspend to Hibernate
power mode after the indicated period of inactivity. (Skips
Suspend mode if that time-out is disabled.)
Sets the period of hard disk inactivity after which the hard disk
stops spinning.
Sets whether power management time-outs occur while the ac
adapter is connected.
Sets the action of the blue power button when pressed for less
than 4 seconds.
Sets whether the system resumes from Suspend if a ring
signal is received.
Sets whether the system resumes from Suspend at a defined
time of day.
Sets the 24-hour time when the system resumes from
Suspend if enabled.
Sets whether the OmniBook suspends after undocking.
Shows the order of boot devices. Move the entries to change
the order.
Saves Setup changes, exits, and reboots.
Discards Setup changes since last save, exits, and reboots.
Does not affect Security and date/time changes.
Restores default settings, stays in Setup. Does not affect
Security and date/time settings.
Discards Setup changes since last save, stays in Setup. Does
not affect Security and date/time changes.
Saves Setup changes, and stays in Setup. Security settings
are saved when changed.
4 minutes
4 hours
2 minutes
Disabled
Suspend
Enabled
Disabled
When Lid Closed
Default
1. Diskette drive
2. Hard drive
3. CD-ROM drive
HP OmniBook 7100