Table 2-8. Removing Display Components - HP OmniBook 900 Service Manual

Hewlett-packard omnibook service manual
Hide thumbs Also See for HP OmniBook 900:
Table of Contents

Advertisement

Component
Bezel, display
Cable, display flex
(12-inch display)
Cable, display flex
(13-inch display)
Cable, display power
Case, display
(12-inch display)
Case, display
(13-inch display)
Hinge
Latch, display
LCD module
HP OmniBook 900

Table 2-8. Removing Display Components

Removal Procedures
Keyboard (page 2-12).
Display (page 2-16).
LCD module (page 2-10).
Keyboard (page 2-12).
Keyboard (page 2-12).
Keyboard (page 2-12).
Display (page 2-16).
LCD module (page 2-10).
Keyboard (page 2-12).
Keyboard (page 2-12).
Display (page 2-16).
See page 2-10.
Additional Steps (See figure on page 4-6)
Remove the display bezel (see page 2-10).
1. Unsnap the flex cable tube from the display case.
2. Remove the screw holding the left hinge arm and
release the flex cable grounding strap.
Reassembly Notes: The grounding strap goes
between the left hinge arm and the display case. It is
held by the hinge screw.
The flex cable wraps around the tube only about 1/2
turn.
1. Remove the left hinge cover.
2. Remove the bezel and display case (see page 2-
10).
3. Disconnect the flex cable from the LCD.
4. Unplug the flex cable from the motherboard.
1. Remove the right hinge cover.
2. Remove the display bezel (see page 2-10).
3. Unplug the power cable from the LCD module
wires.
4. Unplug the power cable from the motherboard.
Reassembly Notes: Insert the display power cable
into the notch in the top case before installing the
hinge cover.
1. Remove the screws holding the hinge arms, then lift
out the hinges.
2. Unsnap the flex cable tube from the display case.
Lift out the flex cable.
3. Remove the two screws holding the display latch,
then lift out the latch.
Reassembly Notes: Install the display latch and other
components into the new display case.
1. Remove the bezel and display case (see page 2-
10).
2. Remove the two screws holding the display latch,
then lift out the latch.
Reassembly Notes: Install the display latch and other
components into the new display case.
1. Remove the display bezel (see page 2-10).
2. 12-inch display: Remove the screw holding the
hinge arm, then lift out the hinge.
13-inch display: Remove the two screws securing
the hinge arm to the LCD module.
Reassembly Notes (12-inch display): Insert the
hinge fully into the case before installing the screw.
1. Remove the display bezel (see page 2-10).
2. Remove the two screws holding the latch, then lift
out the latch.
Removal and Replacement
2-27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents