Table of Contents
Advertisement
Remote Operation
Erasing incoming messages from memory
Erasing a specific message
Press
while listening to the message you want to erase.
4
A long beep and 3 short beeps will sound.
Then the unit will continue with the next message.
Erasing all messages
Press
5
to erase all messages.
A long beep and 3 short beeps will be heard.
Other remote operations
Monitoring the room
You can monitor the sound in the room where the unit is installed.
Press
6
.
You can monitor the room sound for about 30 seconds.
Note:
After 30 seconds, a beep sounds. To continue monitoring, press
Recording a marker message
After playing back the recorded messages, you can leave an additional message.
1. Wait for 3 beeps to tell you that the remote operation has ended.
2. Wait about 10 seconds for 1 beep to prompt you to leave a message.
3. Leave a message after the beep.
Re-recording a greeting message
You can change the contents of the greeting message for the TAD/FAX mode.
1. Press
7
to start recording.
A long beep will sound.
2. Speak clearly up to 16 seconds.
If you pause for over 2 seconds, 6 beeps will sound and the recording will stop. Repeat
from step 1 within 10 seconds.
3. When finished, press
The new greeting message will be played.
68
9
.
6
again within 10 seconds.
Advertisement
Table of Contents
