Displaying The Picture - Hitachi CP-D27WN User Manual

Displaying the picture

1. Activate your signal source. Turn the
signal source on, and make it send the
signal to the projector.
Press the INPUT button on the projector.
2.
Each time you press the button, the
projector switches its input port in turn.
You can also use the remote control to
select an input signal. Press the VIDEO
button for selecting an input signal from
the HDMI, S-VIDEO or VIDEO port, or
the COMPUTER button for selecting an
input signal from the COMPUTER IN1,
COMPUTER IN2, LAN, USB TYPE A or
USB TYPE B port.
3. Use the VOLUME + / VOLUME - buttons
to adjust the volume.
To have the projector silent, press the
MUTE button on the remote control.
4. Press the ASPECT button on the remote
control. Each time you press the button,
the projector switches the mode for aspect
ratio in turn.
5. Use the FOCUS ring to focus the picture.
CAUTION ►If you wish to have a blank screen while the projector's lamp is
on, use the BLANK function. (see User's Manual - Operating Guide)
Taking any other action may cause the damage on the projector.
NOTE • The ASPECT button does not work when no proper signal is inputted.
• For the details of how to adjust the picture, please see User's Manual -
Operating Guide.
• There may be some noise and/or the screen may  icker for a moment when
an operation is made. This is not a malfunction.
VIDEO COMPUTER MY SOURCE/
ASPECT AUTO
MAGNIFY FREEZE
ON
OFF
MY BUTTON
KEYSTONE 1
POSITION
ENTER
ESC
INPUT button
VIDEO COMPUTER MY SOURCE/
ASPECT AUTO
FREEZE
MAGNIFY
ON
OFF
MY BUTTON
KEYSTONE 1
POSITION
ESC
12
DOC.CAMERA
SEARCH BLANK
PAGE VOLUME
UP
VOLUME+ button
DOWN
VOLUME- button
2
MUTE
MUTE button
MENU
RESET
VIDEO button
DOC.CAMERA
COMPUTER button
SEARCH BLANK
PAGE VOLUME
UP
ASPECT button
DOWN
2 MUTE
MENU
ENTER
RESET
F FOCUS ring