Displaying The Picture - Hitachi CP-X2542WN User Manual

Displaying the picture

1.
Activate your signal source. Turn the
signal source on, and make it send the
signal to the projector.
2.
Press the INPUT button on the projector.
Each time you press the button, the
projector switches its input port in turn.
You can also use the remote control to
select an input signal.
Press the VIDEO button for selecting an
input signal from the HDMI1, HDMI2/MHL or
VIDEO port, or the COMPUTER button
for selecting an input signal from the
COMPUTER IN1, COMPUTER IN2,
LAN, USB TYPE A or USB TYPE B port.
3.
Use the VOLUME + / VOLUME - buttons
to adjust the volume.
To have the projector silent, press the
MUTE button on the remote control.
4.
Press the ASPECT button on the
remote control. Each time you press
the button, the projector switches
the mode for aspect ratio in turn.
5.
Use the ZOOM ring to adjust the
screen size.
6.
Use the FOCUS ring to focus the picture.
WARNING ►If you wish to have a blank screen while the projector's lamp
is on, use the BLANK function. (see User's Manual - Operating Guide)
Taking any other action may cause the damage on the projector.
Blocking the beam by something causes high temperature and could result in
fi re or smoke.
(continued on next page)
12
VIDEO COMPUTER MY SOURCE/
DOC.CAMERA
ASPECT
AUTO SEARCH BLANK
FREEZE
MAGNIFY PAGE VOLUME
UP ＋
ON
DOWN
OFF ー
MY BUTTON
KEYSTONE 1 2 MUTE
POSITION MENU
ENTER
ESC
RESET
INPUT button
VIDEO COMPUTER MY SOURCE/
DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON ＋
OFF DOWN ー
MY BUTTON
2 MUTE
KEYSTONE 1
POSITION MENU
ENTER
ESC RESET
VOLUME+ button
VOLUME- button
MUTE button
VIDEO button
COMPUTER button
ASPECT button
ZOOM ring
FOCUS ring