12.
If it is necessary to replace the webcamera/microphone perform the following: Lift the module (1)
from the adhesive holding it in place on the display bezel and disconnect the module connector
(2) if you have not already done so when removing the display cable.
13.
If it is necessary to replace the WLAN antenna cable, follow these procedures:
a.
Position the display back cover face up.
b.
Remove the display brackets by removing the eight Phillips and broadhead screws (1)
securing the hinge brackets to the back cover, and then lift the brackets (2) to remove
them.
c.
Release the wireless antenna transceivers (1) from the display bezel. (The wireless
antenna transceivers are attached to the display bezel with double-sided tape.)
Component replacement procedures
85