System Menu Screen - JVC GY-DV300 Instruction Manual

The displayed menu screens of the SYSTEM Menu Screen differ with the shooting mode and the VTR
mode.
SYSTEM Menu Screen (Shooting mode)
In the shooting mode, the SYSTEM Menu Screen consists of two screens. (1/2 screen and 2/2 screen)
SYSTEM 1/2 screen
Item
● INT
MIC1 INPUT
SEL
● OFF
WIND CUT
MIC1
● OFF
WIND CUT
MIC2
● OFF
+48V MIC1
● OFF
+48V MIC2
AUDIO MODE
● 48K
● SP
REC MODE
Set Value
Selects whether the built-in microphone or a microphone
XLR connected to the MIC 1 input connector should be used.
INT : Use this setting when the built-in microphone should be used.
XLR : Use this setting when a microphone connected to the MIC
1 input connector should be used.
Selects whether or not the wind noise picked up by the internal
ON microphone or a microphone connected to the MIC 1 input
connector is reduced.
OFF : Not reduced.
ON : Reduced.
Selects whether or not the wind noise picked up by a microphone
ON connected to the MIC 2 input connector is reduced.
OFF : Not reduced.
ON : Reduced.
To set whether +48 V power should be supplied to a microphone
ON connected to the MIC 1 or MIC 2 input connector.
MIC 1 and MIC 2 are set separately.
OFF : +48 V power is not supplied.
ON ON : +48 V power is supplied. Use this setting when a
Memo:
"– – –" is displayed when the MIC1 INPUT SEL item is set to
INT, and setting is not possible.
32K Selects the sampling frequency for audio recording (common for
CH-1 and CH-2)
32K : Recording is performed with 12-bit, 32 kHz sampling frequency
48K : Recording is performed with 16-bit, 48 kHz sampling frequency
* 4 channels are available when the DV format is recorded with
12-bit, 32 kHz audio sampling. The GY-DV300 records audio on
the CH-1 and CH-2 channels. The GY-DV300 does not allow
after-recording.
Selects the recording speed mode.
LP SP : Standard Play recording speed mode.
LP : Long Play recording speed mode (recording time is 1.5
times longer than in the SP mode.)
Contents
phantom microphone is used.
E-91