JVC GY-DV300 Instruction Manual page 27

VTR playback mode status indications
VOL.
PL AY
No. Item
1
Audio playback volume Displayed in the VTR mode. Characters indicate the high and low of
indication
2
Time code indication
3
Recording/playback
speed mode indication SP: Standard Play mode
4
Remaining tape time
indication
5
Remaining battery
power indication
q
DV
the playback volume.
The recorded time code data (hours, minutes, seconds, frames) are
shown here in the playback mode.
The indication is turned ON/OFF by setting the TIME CODE item on the
DISPLAY [2/2] menu screen.
The mode in which the tape was recorded is displayed during playback.
LP: Long Play mode
When the remaining tape time indication is set to OFF, this indication is
shown at the position indicated by 4.
Indicates the remaining tape time in 1-minute steps.
The indication is turned ON/OFF by setting the TAPE REMAIN item on
the DISPLAY [2/2] menu screen.
* The indication may not appear when a new tape is loaded, after the
tape runs, the indication appears.
* When used in a cold environment, it may take a little while before the
remaining tape time indication appears.
The remaining battery power is indicated by four different indicators.
Fully charged
battery
w
Contents
Blinking indicator
(no remaining
battery power)
e
r
t
E-27