With The Two Latch Screws (79). Start Both Latch Screws; Before Tightening Either Of Them. Note: The Latch Screws; May Be Preattached To The Left Upright - Pro-Form PFTL61731 User Manual

2. With the help of a second person, carefully tip the
Uprights (97) down as shown. (Note: It may be helpful to
place your foot on one of the Extension Legs [92] as you
tip the Uprights.) Make sure that the Extension Legs
remain in the Uprights.
Attach each Extension Leg (92) with two Extension Leg
Bolts (96) and two 1/4" Washers (39) as shown. Thread
a Leveling Foot (95) into each side of the Upright Base
(97); do not thread the Leveling Feet fully into the
Upright Base.
Attach the two Base Pads (99) to the Upright Base (97)
in the locations shown with two 1" Tek Screws (80).
With the help of a second person, raise the Upright Base
(97) to the vertical position.
3. Attach the Latch Assembly (82) to the Left Upright (84)

with the two Latch Screws (79). Start both Latch Screws

before tightening either of them. Note: The Latch Screws

may be preattached to the Left Upright.

4. Refer to drawing 4c. With the help of a second person,
hold the Console Base (101) near the Uprights (80, 84).
Look under the Console Base and locate the wires on
the sides of the Console Base. Make sure that the wires
are not routed through the openings for the Trays (109,
111). Drawing 4a shows the correct route for the wires.
Drawing 4b shows an incorrect route.
Refer to drawing 4c. Cut the plastic ties holding the Wire
Harness (74) and the pulse wire in the Uprights (80, 84).
Locate the Wire Harness (74) and pulse wire in the
Uprights (97). Connect the Wire Harness and the pulse
wire to the connectors on the sides of the Console Base
(101). Make sure to connect the connectors properly
(see the inset drawings). IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS TURNED ON.
The connectors should slide together easily and
snap into place. If the connectors do not slide together
easily and snap into place, turn a connector and try to in-
sert it again. Insert the excess Wire Harness and pulse
wire up into the Console Base.
2
99
39
97
92
39
3
79
4a
Correct
4c
74
97
6
80
39
92
97
96
95
96
82
84
4b
Incorrect
111
109
101
97
Pulse
Wire
74
99
80
96
95
96