Connecting To The Neutron Series Switch - EnGenius Neutron EWS210AP User Manual

Connecting to the Neutron Series Switch

A) Connect the supplied Power Cord to the EWS Switch and plug the other end into an electrical outlet. Verify the
Power LED indicator is lit on the EWS Switch. Wait for the EWS Switch to complete boot up. It might take few minutes
to complete the process.
9 11 13 15 17 19 21 23 25F 27F
100/1000Mbps
Speed Speed
Link/Act Link/Act
Speed Speed
Link/Act Link/Act
26F 28F
10 12 14 16 18 20 22 24
B) Connect one end of a Category 5/6 Ethernet cable into the Gigabit (10/100/1000) Ethernet port on the Switch's
front panel and the other end to the Ethernet Port on the computer. Verify that the LED on the Ethernet port of the
Switch is green.
9 11 13 C) Connect the EWS AP(s) to the EWS Switch. Verify that the LED on the Ethernet port(s) of the EWS Switch is green. 15 17 19 21 23 25F 27F
100/1000Mbps
Speed Speed
Link/Act Link/Act
Speed Speed
Link/Act Link/Act
26F 28F
10 12 14 16 18 20 22 24
Console
Power
Fault LAN Mode
LED Mode Reset
PoE Max PoE Mode
Console
Power
Fault LAN Mode
LED Mode Reset
PoE Max PoE Mode
Console
1 3 5
Power
Mode Link/Act
Fault LAN Mode
PoE Max PoE Mode
Console
Power
Fault LAN Mode
LED Mode Reset
PoE Max PoE Mode
2 4 6
1 3 5 7 9 11 13 15 17 19
Mode Link/Act
2 4 6 8 10 12 14 16 18 20
1 3 5 7 9 11 13 15 17 19
Mode Link/Act
2 4 6 8 10 12 14 16 18 20
1 3 5 7 9 11 13 15 17 19 21
Mode Link/Act
7 9 11 13 15 17 19 21 23 25F 27F
100/1000Mbps
LED Mode Reset
Speed Speed
2 4 6 8 10 12 14 16 18 20 22
Link/Act Link/Act
Speed Speed
Link/Act Link/Act
8 10 12 14 16 18 20 22 24 26F 28F
21
21 23 25F 27F
100/1000Mbps
Speed Speed
Link/Act Link/Act
Speed Speed
Link/Act Link/Act
22 24 26F 28F
21 23 25F 27F
100/1000Mbps
Speed Speed
Link/Act Link/Act
Speed Speed
Link/Act Link/Act
22 24 26F 28F
25F
23 27F
100/1000Mbps
Speed Speed
Link/Act Link/Act
Speed Speed
Link/Act Link/Act
24 26F 28F