Table of Contents
Advertisement
Operating Your Camera
4. When completed, press the SET button.
Notes
• If you select WDR mode, the following phenomenon may appear by lighting
condition. In these cases do not select WDR mode.
Unnatural color change or unnatural phenomenon on the screen
Noise of bright part on the screen
• According to the area of bright part on the screen there may be the difference of
WDR performance so be sure to adjust the degrees of the visual angle when
installing your camera.
• If you increase WDR level, unnatural phenomenon may appear.
WHITE BALANCE CONTROL
Your camera provides 4 'WHITE BAL.' control modes. You can select the
most suitable one. You can adjust the white balance.
1. Press the SET button to display the SETUP menu and move the arrow
indicator to 'WHITE BALANCE' using the UP or DOWN button.
2. Set 'WHITE BAL.' to the desired mode using LEFT or RIGHT button.
SETUP
CAMERA ID
BACKLIGHT
WHITE BAL.
MOTION DET.
IRIS
SHUTTER
The six WHITE BALANCE control modes are as follows :
W-ATW(Wide Auto Tracking White balance): When color temperature is
2400~12000K, select this mode. (EX. a fluorescent lamp, outdoor)
22
COLOR CCD CAMERA
OFF
WDR
W-ATW
OFF
LEVEL
OFF
User's Manual
S-ATW(Special Auto Tracking White balance): When color temperature is
1800~6000K, specially in sodium lamp, select this mode. (EX. sodium lamp, inside the
tunnel)
AWC(Auto White balance Control): The white balance is automatically adjusted
in a specific environment. In order to obtain the best result, press the SET button while
the camera focuses on white paper. If the environment including the light source is
changed, you have to adjust the white balance again.
MANUAL: To fine adjust, select the Manual mode. You can increase or
decrease the red or blue factor while monitoring the difference on the screen. Set
to 'MANUAL' mode and press the SET button. Increase or decrease the value for
RED(R-Gain) and BLUE(B-Gain), watching the color of the picture, and press the
SET button when you obtain the best color.
Notes
• Proper White Balance may not be obtained under the following conditions, in these
cases select the AWC mode.
When the scene contains mostly high color temperature object, such as a blue
sky or sunset.
When the scene is dim.
If your camera faces fluorescent lamp directly or is installed in the place of the
changing illumination.
MOTION DETECTION
Your camera transmits an alert signal when it detects motion of an object
on the screen. If you connect the camera to an external alarm, you can pay
attention to the screen when the alarm sounds. This feature is useful when
you have to monitor several screens simultaneously. Whenever your camera
detects motion of object displaying 'MOTION DETECTED' with the number
counted up on the screen.
1. Press the SET button to display the SETUP menu and move the arrow
indicator to 'MOTION DET.' using the UP or DOWN button.
COLOR CCD CAMERA
23
User's Manual
Advertisement
Table of Contents
