To Remove The Fascia; To Remove The Window; To Remove The Burner Unit - Valor Fires 963 Installer And Owner Manual

INSTALLER GUIDE

20.4 To remove the fascia.

1. Remove the firefront casting and the front cover
casting.
2. Remove the two screws and washers securing
the bottom of the fascia to the sides of the
convection box.
3. Carefully lift the fascia upward to clear the upper
support bracket on the convection box (See figure
38). Pull the fascia clear and place carefully aside.
4. Refit in the reverse order. Make sure that the
fascia is properly located over the upper support
bracket. See section 16 of this guide for detailed
fitting instructions.

20.5 To remove the window.

1. Remove the firefront casting and the front cover
Figure 38.
casting.
2. Detach and remove the window
assembly. To do this unscrew and
remove the two thumbscrews at the
base of the window assembly. Gently
lift the window assembly upward and
forward (See figure 39). Place the
window assembly and thumbscrews in
a safe place away from the work area.

20.6 To remove the burner unit.

1. Remove the firefront casting and the
front cover casting.
2. Remove the loose ceramic fuel
effect.
3. Support the inlet 'T' connector to
avoid straining the pipework and
Figure 39.
disconnect the appliance from the inlet
'T' connector.
4. Unscrew and remove the screw that
secures the slider arm assembly to the
burner.
5. Detach the burner unit from the convection
box by removing two screws (See figure 40).
6. Replace in the reverse order (When fitting
the screw that connects the control slider to
the burner use a screwdriver - do not leave
as finger tight only).
Figure 40.
Page 42
©
Baxi Heating U.K. Limited 2010.