Final Review - Valor Fires 963 Installer And Owner Manual

INSTALLER GUIDE

19. FINAL REVIEW

1. COMPLETE THE INFORMATION IN THE WARRANTY AND SERVICE SECTION
OF THE OWNER GUIDE (See last pages of the OWNER guide).
2. Visually inspect the appliance. Clean off any marks incurred during installation.
3. Advise the customer how to operate the fire.
4. Explain to the customer that the appliance has a flame failure and spillage
monitoring system. Point out the explanation of this system shown in the owner guide.
Advise that if the fire goes out for any reason, wait at least three minutes before
relighting. Stress that if the monitoring system repeatedly shuts off the fire, the
appliance should be switched off and a competent person should be consulted.
5. Advise that the fire may give off a slight odour while new. This is quite normal and it
will disappear after a few hours of use.
6. Advise that any cleaning must only be carried out when the fire is off and cold.
7. Advise the customer that they should read the owner guide before operating the
fire and always follow the advice in the section headed "Cleaning your fire".
8. Advise the customer that the appliance will operate to its maximum potential if the
flue is primed during the first 20 – 30 minutes of use. To do this, simply set the control
to its highest setting. This will also burn off any carbon deposits that may have formed
during previous use.
If using the appliance for long periods it is beneficial to change between settings. This
will also help to remove any carbon deposits that may form during use.
9. Recommend that the appliance should be serviced and the chimney inspected by a
competent person at least annually.
If the appliance is in premises in the United Kingdom occupied by a tenant, point out
that by law a landlord must have any gas appliance, flue and pipework which is
situated in a tenant's premises checked for safety at least every 12 months.
10. Advise the customer that the fascia, window and ceramic pieces can be cleaned
as described in the owner guide and that the loose ceramic fuel effect pieces must be
replaced as described in the instructions supplied with them.
Stress that no extra ceramic fuel effect pieces must be added over and above
those supplied with the appliance and that any replacements must only be the
authorised spares. Warn that ignoring this advice could cause incomplete
clearance of the products of combustion with consequent health hazards.
11. Inform the customer that the Serial number for the appliance is located on
the information label, located behind the lower front casting and underneath the
burner (See figure 8 on page 62).
12. Hand the literature pack with this guide to the customer.
Page 39
©
Baxi Heating U.K. Limited 2010.