New Sssws/Parameters Added To This Model - Canon FAXPHONE L75 Service Manual

4.2.5 New SSSWs/parameters added to this model

#1 SSSW (service soft switch setting)
SW01 (service soft switch 01: error management)
Bit Function
0 Service error code
1 Error dump list
2 Enter password at confidential
Rx image data transfer
3 Copy function
4 (New) ##300 series service error code
5 Not used
6 Not used
7 User setting restriction
[Bit 4]
Even when Bit0 is set to "Not output", you can select whether or not to output ##300 series Service
Error Codes, caused by hardware malfunction.
When "Output" is selected, ##300 series Service Error Codes are displayed and included in reports.
When "Not Output" is selected, no Service Error Codes are displayed.
SW15 (service soft switch 15: Dial inn FAX/TEL switching function setting)
Bit Function
0 Not used
1 Not used
2 Not used
3 Not used
4 Not used
5 Not used
6 (New) Delect continuous signal at
FAX/TEL switching
7 Not used
[Bit 6]
You may enable or disable detection of ROT continuous signal for FAX/TEL switching.
Normally, only ROT intermittent signals are detected for FAX/TEL switching. If you need to detect
both in view of exchange specifications, select "1" to enable detection.
LASER CLASS 1060P Chapter 4: Maintenance & Service
1
Output
Output
No
No
Output
Setting possible
1
Yes
4-51
0
Not output
Not output
Yes
Yes
Not output
Setting restricted
0
No