Canon FAXPHONE L75 Service Manual page 103

LASER CLASS 1060P Chapter 4: Maintenance & Service
"CHECK PRINTER" (##322~##324)
Check the displayed error code and see the measure to eliminate the error. ( See Page 4-21 .)
"CHECK SUBADDR/PSWD" (#083/#102)
Cause: Password/subaddress does not match.
Solution: Contact the other party and confirm that the subaddress/password that you are using
are correct.
"CLEAR PAPER JAM"
Cause:
Paper jam.
Solution: Clear the paper jam.
"DATA ERROR"
Cause: The registration data in the SRAM was destroyed and a checksum error occurred due
to a dead lithium battery or SRAM failure.
Solution:
(1)
(2)
(3)
"DOC. TOO LONG" (#003)
Cause: The document is longer than 39.4"(1m).
Solution: Use a copy machine to make a reduced copy of the document, then send again.
Cause: It took more than 32 minutes to send, copy, a document or receive a document.
Solution:
Divide the document and send or copy each part separately. Contact the other party
and have them divide the document and send each part separately.
"HANG UP PHONE"
Cause: The handset or the extension telephone is off the hook.
Solution: Put the handset or the extension telephone back on the hook.
"LOAD PAPER"
Cause: The fax is out of paper.
Solution:
Add more paper to the sheet feeder.
"MEMORY FULL" (#037)
Cause:
The fax's memory is full because it has received too many documents.
Solution: (1)
(2)
Cause: The fax's memory is full because you tried to send too many pages at once.
Solution:
Divide the document and send each part separately.
"NO ANSWER" (#005)
Cause:
The receiving fax machine does not answer.
Solution: Make sure you dialed the correct number. Try again later.
Press the Set button.
Replace the lithium battery.
Replace the SCNT board.
Print out any documents which are stored in memory. Then start the operation
again.
If the memory contains any facsimiles you don't need, delete them.
4-10