Canon FAXPHONE L75 Service Manual page 102

3.2 Errors Shown on the Display
3.2.1 User error message
Look for the applicable error message and implement the appropriate countermeasures.
"BUSY/NO SIGNAL" (#018)
Cause: The receiving fax did not answer within 55 seconds. (T0 time over)
Solution: Contact the other party and have them check their fax.You can try to send the
document manually. For an overseas call, add pauses to the registered number.
Cause: The touch tone/rotary pulse setting on your fax is incorrect.
Solution:
Set your fax to the setting that matches your telephone line.
Cause: The other party is not using a G3 machine.
Solution:
Contact the other party and have them send or receive the document using a G3
machine.
Cause:
The other party's fax is not working.
Solution: Contact the other party and have them check their fax.
Cause: The telephone number you dialed is busy.
Solution: Try sending the document at a later time.
"CHANGE CARTRIDGE"
Cause:
The toner cartridge has run out of toner.
Solution: Replace the toner cartridge.
"CHECK COVER"
Cause: The toner cartridge is not installed properly.
Solution: Make sure the toner cartridge is installed properly.
Cause:
Front cover is not closed.
Solution: Close front cover.
"CHECK DOCUMENT" (#001)
Cause: Document jam. This is displayed when the document sensor detects paper, but the
document edge sensor cannot detect the leading edge of the document with 15 seconds
from the start of the feed operation.
Solution: Clear the document jam.
"CHECK PAPER SIZE"
Cause: The size of the paper loaded in the paper tray is different from the paper size set by the
user data menu.
Solution: Set the correct paper size in the "PRINTER SETTING" setting.
"CHECK POLLING ID" (#021)
Cause: Pollimg was impossible because the polling ID or your subaddress/password did not
match.
Solution:
Check the polling ID or subaddress/passwaord with the other party and try polling
again.
LASER CLASS 1060P Chapter 4: Maintenance & Service
4-9