Adjusting The Bosch Mechanical Injection Pump Controls - Xantia - CITROEN XANTIA User Manual

ADJUSTING THE BOSCH MECHANICAL INJECTION PUMP CONTROLS
Engine cold.
- Check the fast idle speed.
- Ensure that the lever (3) is against its screw stop (1) by pushing it in the direction of the arrow
If not, adjust with the cable clamp (2), and then the cable tightener (6).
Engine hot.
- Ensure that the cable (9) is slack.
- Engine stopped : fully depress the accelerator pedal, check that the lever (8) is against its stop (7).
If not, move the position of the spring clip (B).
Adjusting the idle speed.
- Loosen the screw (5) until there is no longer any contact with the end of the screw.
- Move the screw (4) to obtain an engine speed of (see the table on page: 158).
Adjusting the residual output.
- Insert a shim "A" of (see the table on pages 158), between the lever (8) and the screw (5).
Adjust the screw (5) to obtain a speed of (see the table on page 158).
Adjusting the fast idle speed.
- Place the lever (3) against the screw (1) and turn the screw to obtain an engine speed of (see table
on page 158) .
- Check the operation of the manually-operated "STOP" control.
Adjusting the throttle lever switch (C).
- The contacts will open for an accelerator cable travel of 11 mm or a clearance of 8.5 mm at A".
B1HP0YLD
Engine : DHY
161
XANTIA
#
.