Pre-Start Check List; Leak Testing; Lighting Instructions - Brinkmann Dual Sear Gas Grill Owner's Manual

CAUTION: DO NOT use the grill if leaks cannot be stopped. Contact a qualified gas appliance
repair service.
Note: The leak test must be performed in an area that has adequate lighting in order to see if bubbles are
developing.
Property damage, bodily harm, severe burns, and death could result from failure to follow these safety
steps. These steps should be performed after the grill has been assembled and prior to each use. DO
NOT operate this grill until you have read and understand ALL of the warnings and instructions in this
manual.

PRE-START CHECK LIST:

• Ensure that the grill is properly assembled.
• Inspect the gas supply hose for burns, chaffing, kinks, and proper routing before each use. If it is evident there is
excessive abrasion or wear, or the hose is cut, it must be replaced prior the grill being used. Replace with hose and
regulator, Model No. 155-3660-0, which can be obtained by contacting customer service at 800-527-0717.
• Leak check all gas connections and hose. See section on "Leak Testing".
• Ensure that all electrical supply cords are properly grounded. Keep any electrical supply cord and the fuel supply
hose away from any heated surfaces. Hose should be at least 3 inches from hot surfaces.
• Position your grill on level ground in a well ventilated location, a safe distance from combustible materials, buildings
and overhangs.
• Properly place the empty grease tray under the grease drain hole in the bottom of the grill to catch grease during use.
• DO NOT obstruct the flow of combustion and ventilation air.
Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any
of the warnings and instructions contained in the preceding sections of this manual.

LIGHTING INSTRUCTIONS:

Follow the instructions exactly.
1. OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside
the grill. An explosion could occur if grill lid is down.
2. Check that all burner control knobs and the cylinder valve are turned to the "OFF" position.
3. Turn on the fuel supply by rotating the cylinder valve knob counter-clockwise to full open.
4. DO NOT stand with head, body, or arms over the grill when lighting.
9
WARNING
WARNING
WARNING