Installing The Sy1 Board - Epson PhotoPC 3000Z Service Manual

EPSON PhotoPC 3000Z

4.3.2 Installing the SY1 Board

1. Insert the connector of ASSY, WIRE (2) to the SY1 board (1).
2. Connect the connector CN303 of SY1 board to the connector CN106 of the
CA2 board. Secure it with 2 screws (1.7x5).
3. Connect the harness from the TB1 board to the connector CN301 of the
SY1 board.
C H E C K Do the following preparation so that the harnesses would not
P O I N T
interfere with the shutter operation.
Set the harness from the TB1 board to the same height
with connector CN302 of the SY1 board and strain it a
little bit.
The core of the harness from the TB1 should be pressed
and secured under the super capacitor C3001.
Disassembly and Assembly
(1) SY1 board
CN302
Super capacitor
C3001
Core
TB1 Board
Figure 4-8. Installing the SY1 Board
Assembly
Revision A
CN301
(2) ASSY, WIRE
(3) screw
(3) screw
65