Overview; Check Items - Epson PhotoPC 3000Z Service Manual

EPSON PhotoPC 3000Z

6.1 Overview

PhotoPC 3000Z requires no specific maintenance (lubrication / adhesion /
cleaning).
Camera should be cleaned according to its necessity, however, such as for
dust incoming at the repairing service or fingerprint. The following table lists
the check items before sending the camera back to users.

6.1.1 Check Items

Check the camera with the following table. If you find any dust or dirt, clean
the camera, referring to Ch4. Certain dirt such as dust and fingerprints can be
removed by tapping the cellophane tape.
Maintenance
No.
Check the lens viewer inside / outside if it is dirty with
fingerprints etc.
1
Check if any cable such as power supply cable is visible.
Is the operation of the rotary switch smooth?
2
Can you feel it clicked when you click the switch?
Are there any dust or cables visible inside / outside of the
3
flash window?
Is there any fingerprints or dust on the LCD panel surface
4 glass on SY1 board or inside / outside of the acrylic plate of
rear cabinet?
5 Is there any fingerprint or dust on the lens surface?
Is there any fingerprint or dust inside / outside of the LCD
6
monitor window?
7 Does the battery cover open and close normally?
8 Is the compact flash card inserted normally?
Is the rubber cover that covers various connectors and serial
9
connectors properly secured to the rear cabinet?
10 Is the various panel switch operation done properly?
11 Is the appearance clean?
Overview
Table 6-1. Check Items
Check Item
Revision A
OK / NG
OK NG
OK NG
OK NG
OK NG
OK NG
OK NG
OK NG
OK NG
OK NG
OK NG
OK NG
89