System Configuration - Digitus ADVANCED NETWORK SURVEILLANCE CAMERA User Manual

4. SYSTEM CONFIGURATION

Before using the network camera, make sure you have installed the supplied software, "Video
Viewer", and configure network settings. If not, please refer to your installer or the installation guide.
Note: It's recommended to consult with your installer before changing system
configurations.
Note: You need to be the supervisor to enter the system configuration page. If not,
please re-log into the camera with the supervisor user level.
Click " " and select "
are listed as a tree structure on the left panel as follows.
Main Menu Sub-menu
General
Log
Account
OnLineUser
Trigger
Network
QoS
DDNS
SNTP
FTP
MAIL
Filter
UPnP
Video
Color
Time
" to enter the system configuration page. All the system configurations
What you can do for this function?
1. Check the firmware version & MAC address of the camera.
2. Change the camera title.
Check the system event logs.
1. Create a new user account with different access privilege.
2. Modify or delete an existing user account.
Check the current online user(s).
1. Enable / disable the motion detection.
2. Set the motion detection area.
3. Select the event notification method.
Configure network settings.
Limit the data flow for live streaming.
Enter DDNS information when the network type is PPPOE or DHCP.
Synchronize your camera time with the networked computer systems.
Enter the FTP information for event notifications when "FTP" is chosen in "General" →
"Trigger".
Enter Email information for event notifications when "Email" is chosen in "General" →
"Trigger".
Choose to permit or block the IP address(es) which can access this camera.
Allow this camera to be detected among devices within the same network area for easy and
quick usage.
Set the image resolution, quality and frame rate.
Adjust the color performance.
Set daylight saving time and the current time.
12