Viewing The Wireless Status - Cisco RV 120W Administration Manual

Introduction
Viewing Device Statistics
Cisco RV 120W Administration Guide
Available Access Points Table
The table displays the list of Access Points currently enabled in the device. The
table also displays information related to the Access Point, such as Security and
Encryption methods used by the Access Point.
• SSID—This is the Service Set Identifier (SSID) that clients use to connect to
the AP that has this profile. It is referenced in the AP tables and statistics.
• BSSID—The 48 bit unique identifier of the Basic Service Set (BSS) to which
the Access Point belongs.
• Profile Name—This is the unique (alphanumeric) identifier of the wireless
profile attached to the Access Point.
• Security—This field displays the type of wireless security (if any) assigned
to this profile.
• Encryption—This field displays the encryption type that is assigned to the
profile: TKIP, AES, TKIP + AES.
• Authentication—This field displays the client authentication method that is
configured in the profile: PSK, RADIUS, PSK + RADIUS.

Viewing the Wireless Status

This page shows a cumulative total of relevant wireless statistics for the radio and
APs configured on the device. The counters are reset when the device is
rebooted.
Radio Statistics
A given radio can have multiple virtual APs (VAPs) configured and active
concurrently. This table indicates cumulative statistics for the available radio(s).
• Packets—The number of transmitted/received (tx/rx) wireless packets
reported to the radio, over all configured APs.
• Bytes—The number of transmitted/received (tx/rx) bytes of information
reported to the radio, over all configured APs.
• Errors—The number of transmitted/received (tx/rx) packet errors reported
to the radio, over all configured APs.
• Dropped—The number of transmitted/received (tx/rx) packets dropped by
the radio, over all configured APs.
1
25