Advertisement
Setting up the board
Please, verify the EVB before applying the power supply:
•
All jumpers (J1-J8) are set
•
CPU is inserted firmly in the socket
•
Oscillator is inserted
Use with ic3000 BDM debugger
•
Insert the MC9S12X iCARD to iC3000 Active Emulator
•
Connect standard 6-pin BDM cable to debug connector P4. Pay attention to pin 1.
•
First turn the emulator on and then power the target. When switching off the system, first
switch off the target and then the emulator.
•
Start winIDEA, open a project and carry out the debug reset. The system should be ready for
debugging. Refer to other documents for more details on the debugging.
There are two push buttons on the board designated as RESET and IRQ. RESET is connected to
CPU reset via jumper J3. Make sure that 'Reset from target' option is checked in winIDEA when using
RESET button and the development system is connected to the board. IRQ push button is connected
to CPU external interrupt pin PE1 via jumper J4. Both jumpers must be set to allow 'Reset from target'
and external interrupt.
iSYSTEM, May 2004
Getting started
3/8
Advertisement
