J:end Setting - FujiFilm FinePix6800Zoom Service Manual

4.Adjustment and Check
J: End Setting
Press J on your PC keyboard to select End setting from the adjustment menu. Within End setting, conduct Select the
destination, Choose repair position operations and the USB-ID Input, then conclude the program.
Pressing J on the adjustment menus screen will return you to the destination selection screen, so select your destination.
When destination selection is complete, the repair position selection will be confirmed. Press Enter to complete operation. (Fig. 52)
Press the Enter key to write the data that switches the camera from Jig mode to normal mode. The camera will not
operate in Jig mode once the power is off. (Fig. 53)
Press the Enter key.
Press the Enter key again to end adjustment.
Please pull out DC power supply of the camera. (Fig.54)
Conclude the operation by selecting [Operation] -> [End].
(note)
Since a USB device must be unique among individual units and be the only such device in the world, USB standards mandate
that a unique ID be given to each unit. Accordingly, if the main PWB assembly is replaced, the ID of the repair center must be
entered to grant a new unique device ID. The location of the repair centers are shown in the table below. (Writing this data to
the EEPROM is performed by the PC adjustment software. Follow its instructions.)
Repair position
America
Canada
Hawaii
Taiwan
Others
<< Repair position ID NO. >>
**Indicates ASCII code ( ) indicates decimal
notation
30
Fig.51
Fig.53
U_model
Repair position ID
61(A)
62(B)
63(C)
64(D)
65(E)
FinePix6800Zoom(U/E/EG) SERVIS GUIDE
U
Fig.52
Fig.54
E/EG_model
Repair position Repair position ID
England
Germany
France
Spain
Italy
Natherlands
Belgium
Sweden
Switerland
Norway
Finland
Singapore
Others
66(F)
67(G)
68(H)
69(I)
6A(J)
6B(K)
6C(L)
6D(M)
6E(N)
6F(O)
70(P)
71(Q)
72(R)