4-3-5.Command Descriptions For[Ffw.exe] - FujiFilm FinePix6800Zoom Service Manual

FinePix6800Zoom(U/E/EG) SERVIS GUIDE
(4)Etc.
From the [Customize] dialog box, select [Etc.]. This is
used for other settings. (Fig. 11)
of auto-measure
Change mode
Use Japanese font
In [Etc.], setting [Don't show OK NG] to off will allow
[OK] to be displayed on the computer screen if the
adjustment is good and [NG] to be displayed if it is
bad. (Either setting can be used.)
Fig.11
Apply & OK
(5)
This saves the settings made in [Customize].
(Fig. 12)
*Always click [Apply] and [OK] after all
the settings have been completed.
This will save the settings.
Fig.12
(2)
Precautions when making
O:After adjustments have been completed,
the DC power supply of the camera is
pulled out forcibly, and adjustment is fin-
ished.
O:If the power switch for the camera has been
set to off during adjustment mode (during
camera service mode), disconnect the DC
input terminal and then reconnect it be-
fore turning the power for the camera on
again.
O:If a [NG] appears during adjustment and the
program stops, restart the adjustment soft-
ware and redo the adjustment.
O
Do not check(=not used)
Do not check(=not used)
(1)
adjustments
4.Adjustment and Check
4-3-5. Command descriptions for [FFW.exe]
Fig.13
Menu Command
Operation Start
Stop
Halt
Step0
End
Program Re_load
Select
Edit
Data ad[]
rd[]
SW
fsw
EVR
Mode Fili Recording
NGSTOP
STEP
LINE
AUTO
Setting OKNG clear
Mode setting
Auto Adjustment
Help Help
Help(FF)
FOCAS
Version
(Note 1) : Please refer to the help section of the basic
software for details.
(Note 2) : Always reload after editing the program.
While the user program can be edited, it should
never be performed unless specified as changes to
the program could cause it to malfunction.
Contents
Start of the program
Stop of the program
Halt of the program
Don't use it(note.1)
Closes of the program
Re_load of the program
(*.ff) (note.2)
Select of the program(*.ff)
Edit of the program(*.ff)
Don't use it(note.1)
Don't use it(note.1)
Don't use it(note.1)
Don't use it(note.1)
Data to the EEPROM are writ-
ten/read.(4-3-5 reference.)
Don't use it(note.1)
When adjustment is ng,
a program is given up once.
Don't use it(note.1)
Don't use it(note.1)
Don't use it(note.1)
Don't use it(note.1)
Mode setting
A setup of practice of "Auto
Adjust" in the user program
Help for the bacic software
Help for the user program
It isn't used
The version information
of the basic software
19