E]: End Setting - FujiFilm FinePix 2600Zoom Service Manual

FinePix2600Zoom (U/E/EG) SERVICE GUIDE

4-3-9. [E]: End Setting

(destination setting, USB ID write, product mode setting)
O The End setting consist of the following settings.
* destination setting
* USB ID write
* Product mode setting (mass storage identification)
O The setting must always be run when the adjustment soft-
ware is terminated. Failure to run Terminal Setting will pre-
vent identification as Mass Storage when the camera is con-
nected to the PC.
O USB ID write details
1) USB ID write requires that the USB device (in this case
FinePix 2600Zoom) be unique throughout the world. For
this reason, each device has a unique ID as determined
by the USB standard. If multiple devices with the same
USB ID are connected to a single PC, the PC will be
unable to identify each USB device, thus preventing op-
eration.
2) Automatically written USB IDs are as follows.
Item
Repair Date Date information is acquired from
the PC and written.
Administrator ID C(43)
Repair <U_model>
Station U.S.:61(a)
Canada:62(b)
Hawaii:63(c)
Taiwan:64(d)
Others:65(e)
<E_EG model>
England:66(f)
Germany:67(g)
France:68(h)
Spain:69(i)
Italy:6A(j)
Netherlands:6B(k)
Belgium:6C(l)
Sweden:6D(m)
Switzerland:6E(n)
Norway:6F(o)
Finland:70(p)
Singapore:71(q)
Others:72(r)
Repair A serial No. is assigned
SerialNo. automatically and written
Numbers in ( ) indicate decimal numbers. Other numbers are
ASCII numbers.
<Step1>
[E] is selected from the adjustment item select screen
(Figure 3). (=[E] of the keyboard of PC is pressed.)
--->The [End seting start screen(Figure 22)]displays.
<Step2>
The destination model is selected.
* The screen where U-model was selected is displayed.
[A] of the keyboard of PC is selected.
--->The [destination setting end screen(Figure 23)] dis-
plays.
Details
4. Adjustment and Inspection
<Fig.22> End seting start screen
<Fig.23> destination setting end screen
27