F12]: End Setting - FujiFilm FinePix F601 Zoom Service Manual

FinePix F601 Zoom (U/E/EG) SERVICE MANUAL

4-19. [F12]: End Setting

(Destination setting, USB ID write, Product mode setting)
O The End setting consist of the following settings.
* Destination setting
* USB ID write
* Product mode setting (mass storage identification)
O The setting must always be run when the adjustment soft-
ware is terminated. Failure to run Terminal Setting will pre-
vent identification as Mass Storage when the camera is
connected to the PC.
O USB ID write details
1) USB ID write requires that the USB device (in this case
FinePix F601 Zoom) be unique throughout the world.
For this reason, each device has a unique ID as deter-
mined by the USB standard. If multiple devices with the
same USB ID are connected to a single PC, the PC will
be unable to identify each USB device, thus preventing
operation.
2) Automatically written USB IDs are as follows.
Item
Repair Date Date information is acquired from
the PC and written.
Administrator ID C(43)
Repair <U_model>
Station U.S.:61(a)
Canada:62(b)
Hawaii:63(c)
Taiwan:64(d)
Others:65(e)
<E_EG model>
England:66(f)
Germany:67(g)
France:68(h)
Spain:69(i)
Italy:6A(j)
Netherlands:6B(k)
Belgium:6C(l)
Sweden:6D(m)
Switzerland:6E(n)
Norway:6F(o)
Finland:70(p)
Singapore:71(q)
Others:72(r)
Repair A serial No. is assigned
SerialNo. automatically and written
Numbers in ( ) indicate decimal numbers. Other numbers
are ASCII numbers.
<Step 1>
Select [F12] from [Adjustment Select Screen (Fig.4)] (ie
press the [F12] key on the computer).
---> The [End Setting Start Screen (Fig.33)] is displayed.
<Step 2>
Follow instructions on the [End Setting Start Screen
(Fig.33)], and press the [Enter] key on the computer.
---> The [Destination Settings Screen (Fig.34)] is displayed.
* This example uses U-MODEL and U.S.A as the repair site.
<Step 3>
Follow instructions on the [Destination Settings Screen
(Fig.34)], and press the [A] key on the computer.
---> The [U-MODEL Select Screen (Fig.35)] is displayed.
Details
4. Adjustment
<Fig.33> End Setting Start Screen
<Fig.34> Destination Settings Screen
<Fig.35> U-MODEL Select Screen
<Fig.36> Save USB ID Screen (U.S.A)
43