Honda CBR1000RR 2006 Owner's Manual page 198

Installation
1. Install the side collars and position the
wheel and rear brake bracket.
While installing the wheel, carefully
fit the brake disc between the brake
pads to avoid damaging the pads.
Avoid getting grease, oil, or dirt on
the disc or pad surfaces. Any
contamination can cause poor brake
performance or rapid pad wear after
reassembly.
If You Have a Flat Tire
2. Make sure that the lug ( ) on the rear
brake bracket is located in the slot ( )
on the swingarm (
(8) lug
(9) slot
Taking Care of the Unexpected
8
9
10 ).
(8)
(9)
(10)
(10) swingarm
(cont'd)
189