Drive Chain; Servicing Your Honda (Cont'd) - Honda CBR1000RR 2006 Owner's Manual

An endless (riveted master link) chain
connects the countershaft and rear wheel
sprockets. The O-ring chain uses rubber
rings between the side plates of the pin
and roller links to seal in the
manufacturer-installed lubricating grease
and keep out moisture and dirt.
The service life of the chain depends on
proper lubrication and adjustment. Poor
maintenance can cause premature wear or
damage to the drive chain or sprockets.
The drive chain should be checked,
adjusted, and lubricated as part of the pre-
ride inspection (page 49 ).
Under severe usage, or when the
motorcycle is ridden in unusually dusty or
muddy areas, more frequent maintenance
will be necessary.
Before servicing your drive chain, turn the
engine OFF, lower the side stand, and
check that your transmission is in neutral.
It is not necessary to remove or replace the
drive chain to perform the recommended
service in the Maintenance Schedule.
Servicing Your Honda

Drive Chain

145