Setting The Time Code; Specifying The Time Code (Tc Preset) - Panasonic AG-MDR15P Operating Instructions Manual

Setting the time code

Setting the time code
In the [TC/UB SETUP] setup menu, set the
following time code related items. (Page 88)
• TC MODE
(Only when [SYSTEM FREQ] is set to [59.9Hz])
• TCG
• SDI REGEN
• TC PRESET
When [SDI REGEN] is set to [ON],
the [TC MODE], [TCG] and [TC PRESET]
settings cannot be changed.
Specifying the time code
(TC PRESET)
Set [TC PRESET] to record a value of your choice
as the initial time code setting to be used at the
start of recording.
1
Press the portable recorder's [POWER]
button for 2 seconds or longer to turn on
the power.
2
Press the [MENU] button.
Using the setup menus (Page 27)
3
Select [TC/UB SETUP] → [TC PRESET].
4
Press to move to [YES], and then press
the [ENTER] button.
5
When the screen below appears, set the
time code value.
Press to select the time code value.
Press to move to the next digit, and then
press again to select the value.
Example: To set 10 hours, 23 minutes, 46
seconds, frame 20, select the time code
value "10h23m46s20f."
Press the [USER] button while setting the time
code to reset the time code to zero.
6
Press the [ENTER] button when you have
finished setting the time code.
7
Press to move to [YES], and then press
the [ENTER] button.
With this portable recorder, the time code value is
adjusted in accordance with the recording format
and frame rate. When shooting is performed with
the recording format set to 1080/24P or 720/24P,
recording is performed 4 frames at a time. For
this reason, if you change the recording format or
frame rate, it may result in discontinuity from the
last time code value of the previous recording.
(Only when [SYSTEM FREQ] is set to [59.9Hz])
Hour
Minute
Second
Frame
37