Updating The Portable Recorder; Maintenance Inspections; Cleaning; Storage Precautions - Panasonic AG-MDR15P Operating Instructions Manual

Updating the portable recorder

For details on updating the portable recorder, see the support page of the following website.
http://pro-av.panasonic.net/

Maintenance Inspections

For your safety, it is recommended that maintenance inspections are carried out on an annual basis.

Cleaning

When cleaning, do not use benzene or thinner.
Using benzine or paint thinners may deform the recorder and/or cause the surface finish to peel off.
Cleaning procedure
1. Before proceeding with maintenance, disconnect the AC cable from the power outlet.
2. Use a soft, clean cloth to wipe the recorder. To remove stubborn dirt, wipe the recorder with a cloth
moistened with neutral detergent that has been diluted with water and then use a dry cloth to take up the
remaining moisture.
3. Use a cloth moistened in ethanol for disinfection and thoroughly wrung out to remove dust and dirt from
the recorder.
4. Be sure to thoroughly dry the recorder after cleaning it with ethanol for disinfection.

Storage Precautions

Before storing the recorder, remove the SD
Memory Card.
Store all of these items in a place with low humidity
and relatively constant temperature.
[Recommended temperature range: 15 °C to 25 °C
(59 °F to 77 °F )]
[Recommended relative humidity: 40 % to 60 %]
Portable recorder
• Wrap the recorder in a soft cloth to keep the dust
off.
100
SD Memory Cards
• After ejecting an SD Memory Card from the unit,
be absolutely sure to stow it in its own case.
• Do not leave SD Memory Cards in areas where
corrosive gases, etc. are present.
• Do not leave the cards inside vehicles, in places
exposed to direct sunlight or in other places
where the temperature is high.
• Do not leave the cards where the humidity level
is high or where there are high concentrations
of dust.