Honda VT1300CX Fury Owner's Manual page 181

If You Have a Flat Tire
5. Tighten the rear brake bracket bolt to
the specified torque:
51 lbf·ft (69 N·m , 7.0 kgf·m)
6. Install the rear axle nut and washer.
7. Tighten the rear axle nut to the
specified torque:
94 lbf·ft (127 N·m , 13.0 kgf·m)
8. Install the axle holding bolt and washer.
9. Tighten the axle holding bolt to the
specified torque:
20 lbf·ft (27 N·m , 2.8 kgf·m)
10. After installing the wheel, apply the
brake several times. Check for free
wheel rotation after the brake is
released. Recheck the wheel if the brake
drags or the wheel does not rotate freely.
174
Taking Care of the Unexpected
11. Install the muffler, muffler bracket bolt
A, B, nuts and washers.
Before installing the muffler, replace
the muffler gasket with a new gasket.
Tighten the nuts and bolts to the
specified torques:
exhaust pipe joint nuts:
17 lbf·ft (23 N·m , 2.3 kgf·m)
muffler bracket bolt A, B and nuts:
20 lbf·ft (27 N·m , 2.8 kgf·m)
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
Improper assembly may lead to loss of
braking capability.