Lenoxx CD7400 Instruction Manual page 6

FM & FM-STEREO RECEPTION
SET THE FM MODE SELECTOR AT "MONO" POSITION. PROGRAMS ARE RECEIVED IN MONO MODE. IN
PARTICULAR WHEN STEREO SIGNALS ARE WEAK. IT IS PREFERABLE TO RECEIVE THE PROGRAM IN
MONO.
SET THE FM MODE SELECTOR AT "ST" POSITION FOR RECEIVING STEREO PROGRAMS. THE "ST"
INDICATOR WILL APPEAR ON LCD TO SHOW FM STEREO PROGRAM IS RECEIVING.
HINTS FOR BEST RECEPTION:-
- AM/LW : THE RECEIVER HAS A BUILT-IN MW/LW BAR ANTENNA. IF AM/LW RECECPTION IS WEAK,
SLIGHT ROTATE OR RE-POSITIONING OF THE UNIT WILL USUALLY IMPROVE THE AM/LW RECEPTION.
- FM : THE RECEIVER HAS A BUILD-IN FM WIRE ANTENNA HANGING AT THE REAR CABINET. THIS WIRE
SHOULD BE TOTALLY UNRAVELED AND EXTENDED FRO BEST RECEPTION.
PHONO
NOTED:
- REMOVE THE STYLUS PROTECTOR.
- BE SURE THAT THE TONE ARM IS BEING DETACHED FROM THE TONE ARM
REST BEFORE OPERATING, AND RE-SECURED AGAIN AFTERWARDS.
1. PRESS THE " PHONO " FUNCTION SWITCH.
2. SET THE SPEED SELECTOR TO THE PROPER POSITION DEPENDING ON THE
RECORD TO BE PLAYED.
3. PLACE THE RECORD ON THE PLATTER (USE THE SPINDLE ADAPTOR IF REQUIRED).
4. LIFT THE TONE ARM FROM THE REST AND SLOWLY MOVE IT TO THE RECORD SIDE.
THE PLATTER WILL BEING TO ROTATE.
5. PLACE THE TONE ARM TO THE DESIRED POSITION OF THE RECORD.
6. ADJUST THE VOLUME TO THE DESIRED LEVEL.
7. AT THE END OF RECORD, THE PLATTER WILL AUTOMATICALLY STOP ROTATING. LIFT THE TONE ARM
FROM THE RECORD AND RETURN IT TO THE REST.
8. TO STOP MANUALLY, LIFT THE TONE ARM FROM THE RECORD AND RETURN IT TO THE REST.
REMARK : AS SOME KIND OF RECORD THE AUTO-STOP AREA WAS OUT OF THE UNIT SETTING, SO IT WILL
STOP BEFORE THE LAST RACK FINISH. IN THIS CASE, SELECT THE AUTO-STOP SWITCH TO " OFF
" POSITION, THEN IT WILL RUN TO THE END OF THE RECORD BUT WILL NOT STOP AUTOMATICALLY (TURN
OFF THE UNIT BY POWER BUTTON OR SWITCH BACK THE AUTO-STOP SWITCH TO " ON " POSITION TO
STOP THE PLATTER ROTATE). THEN PUT BACK THE TONE ARM TO THE REST POSITION.
PLAYING COMPACT DISC
GETTING STARTED
1. PRESS "CD" BUTTON.
2. PRESS "OPEN/CLOSE" BUTTON TO OPEN THE CD DOOR.
3. PLACE A CD WITH THE PRINTED SIDE FACING UP INSIDE THE TRAY.
4. PRESS THE "
OTHER DISC COMPARMENT.
5. PRESS THE "OPEN/CLOSE" BUTTON TO CLOSE THE CD DOOR.
6. CD SEARCH IS PERFORMING, THE DISPLY WILL SHOW THE TOTAL NUMBER OF DISC, NUMBER OF
TRACKS & PLAYING TIME OF DISC.
NOTED : CD SEARCHING WILL BE PERFORMAED EVERYTIME WHEN SWITCHING TO CD MODE OR
CLOSING THE CD DOOR. ALL CD FUNCTIONS WILL BE RESPONSED ONLY AFTER THE CD SEARCHING IS
COMPLETED.
PLAY / PAUSE MODE
1. PRESS THE "PLAY/PAUSE" BUTTON TO START PLAYBACK, THE FIRST TRACK OF THE FIRST DISC WILL
BE PLAYED AND THE PLAY INDICATOR WILL APPEAR ON THE LCD DISPLAY.
2. OR PRESS EITHER THE " DISC 1 " , " DISC 2 " , " DISC 3 " BUTTON, UNIT WILL PLAY THE DISC INSIDE
THE DESIRE TRAY DIRECTLY.
3. TO INTERRUPT, PRESS THE "PLAY/PAUSE" BUTTON ONCE, AND THE DISPLAY WILL START FLASHING.
PRESS AGAIN TO RELEASE & RESUME PLAYBACK.
" OR " DISC-CH " BUTTON TO TURNING THE CD TRAY, AND LOADING OUT THE
EN-5