Setting The Clock; Precautions For Use; Listening To Radio - Lenoxx CD7400 Instruction Manual

PRECAUTIONS FOR USE

INSTALLATION
•
UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.
•
DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAINS VOLTAGE AND BEFORE
ALL OTHER CONNECTIONS HAVE BEEN MADE.
•
DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF SEVERAL CENTIMETERS
AROUND THE UNIT FOR VENTILATION.
CONNECTION
1. CONNECT THE POWER CORD TO AC OUTLET.
2. WHEN YOU FIRST PLUG THE UNIT INTO THE MAINS, THE UNIT WILL GO INTO STANDBY MODE.
3. CONNECT THE SPEAKER WIRE TO THE SPEAKER TERMINAL LOCATED ON THE REAR SIDE OF THE
UNIT.
4. TURN ON THE POWER AND SELECT " CD " FUNCTION. IF THE LCD DISPLAY IS ON WITH BACKLIGHTING,
IT MEANS THE POWER SUPPLY IS NORMAL. NOW YOUR SYSTEM IS READY TO PLAY THE MUSIC.

SETTING THE CLOCK

1. SET UNIT IN STANDBY MODE.
2. PRESS THE "MEM/CLK-ADJ" BUTTON, THE FIRST SECOND DIGIT OF "00" IS FLASHING. PRESS
BUTTON TO SET THE CORRECT HOUR. PRESS "MEM/CLK-ADJ" BUTTON TO STORE THE CORRECT
HOUR.
3. THE THIRD & FOURTH DIGIT OF "00" IS FLASHING, PRESS THE
CORRECT MINUTES. PRESS "MEM/CLK-ADJ" TO STORE THE CORRECT MINUTE.
4. TO SELECT 12/24-HOUR DISPLAY MODE, HOLD THE " STOP " BUTTON REPEATEDLY TO CHANGE MODE.

LISTENING TO RADIO

MANUAL TUNING
1. PRESS "TUNER/BAND" BUTTON AND SELECT THE DESIRED BAND (AM OR FM).
2. TUNE TO THE REQUIRED STATION BY PRESSING THE TUNING "+" OR "-" BUTTON.
3. ADJUST VOLUME CONTROLS TO THE DESIRED VOLUME LEVEL.
AUTO TUNING
1. PRESS "TUNER/BAND" BUTTON AND SELECT THE DESIRED BAND (AM OR FM).
2. PRESS AND HOLD THE TUNING "+" OR "-" BUTTON FOR 1-2 SECONDS AND THEN RELEASE
3. THE UNIT WILL START SEEKING AUTOMATICALLY AND STOP UNTIL A RADIO STATION IS REACHED.
4. REPEAT STEP 3 & 4 UNTIL THE DESIRED RADIO STATION IS BEING REACHED.
5. ADJUST VOLUME CONTROLS TO THE DESIRED VOLUME LEVEL.
PRESET STATIONS
YOU CAN STORE UP TO TOTAL OF 20 RADIO STATIONS IN THE MEMORY.
1. SET TO RADIO MODE
2. TURN TO THE DESIRED RADIO STATION BY " MANUAL" OR "AUTO" TUNING METHOD.
3. PRESS "MEM/CLK-ADJ" BUTTON TO ENABLE PROGRAM STATE.
4. PRESS "REPEAT/M-UP" BUTTON TO SELECT THE DESIRED STATION MEMORY FOR STORAGE.
5. PRESS "MEM/CLK-ADJ" BUTTON AGAIN TO CONFIRM THE SETTING.
6. REPEAT STEP 2 TO 5 TO STORE OTHER STATIONS.
7. PRESS "M-UP" OR "M-DN" BUTTON TO SELECT THE PRESET STATIONS IN ORDER.
8. TO RETURN NORMAL TUNER MODE, LEAVE KEYS FREE.
THERE ARE 5 SECONDS FOR PROGRAM STATE, AFTER 5 SEC. THIS STATE WOULD RELEASE TO
NORMAL TUNER MODE AUTOMATICALLY.
YOU CAN OVERWRITE A PRESENT STATION BY STORING ANOTHER FREQUENCY IN ITS PLACE.
EN-4
OR BUTTON TO SET THE
OR