Eight-Event Totalrecall; Programmable Features; Using Cliffnet Wizard Pro; Programming User-Selectable Features - Clifford Prime Level Three Security Upgrade Package Installation Manual

Security upgrade package

Hide thumbs

Table Of Contents

Table of Contents

Color profile: Disabled

Composite

Default screen

1. With the ignition OFF, press and hold the valet switch (at the rear of the LED assembly)

to the right.

2. Use the remote control to lock, then unlock, then release the valet switch.

3. The LED will flash 2–7 times, pause, then flash 2–7 times, etc.

4. Refer to the following chart. The first set of flashes was the most recently activated trigger

or sensor. The next is the second most recent, and so on up to as many as the last eight.

CliffNet Wizard PRO provides an on-screen written report of these activations.

LED flashes

2 flashes

4 flashes

5 flashes

6 flashes

7 flashes

An attempt was made to turn on the ignition while the system was armed

The Level THREE comes preprogrammed as noted in bold text in the following tables.

The CliffNet Wizard PRO software provides an intuitive access to all installer and end-user

features through a user-friendly, graphical user interface and provides extensive diagnostic

capabilities. See www.clifforddealer.com to download a free copy of the program (a #60-509

cable set is required to connect your Windows PC or palmtop to the G4 DataPort).

1. Turn the ignition to the "ON" position or start the engine.

2. Enter the factory preset valet/programming code of "2" by toggling the valet switch

(located behind the LED assembly) to the left two times, then to the right (LED on).

3. Immediately hold to the left for about 3 seconds until you hear one horn beep* and the

LED turns on to confirm the system is in the "Feature Select" position.

4. Toggle the switch to the right once, then pause. Pause. You will hear a confirmation beep.

5. Within five seconds, select the feature by toggling the switch to the left the number of

times indicated. You'll hear a beep each time to help you count.

6. If there is a NOTE for the selected feature, perform the actions noted.

7. Pause. You will hear either one or two beeps: two beeps = ON, one beep = OFF.

8. You can select another feature, or you can exit program mode:

a. To select another feature, repeat step 5 within the next five seconds (after five seconds,

three beeps indicate return to step 4).

b. To exit program mode, turn the ignition off (you'll hear three beeps and the LED will

turn off), or wait 60 seconds for the system to automatically exit program mode.

D:...-923 Level 3 install manual.vp

Mon Aug 02 10:56:53 1999