Mandatory Master Remote Control Addition; Delayed Courtesy Lights; Remote Control Operation; Eight-Event Totalrecall - Clifford Prime Level TWO Installation Manual

MANDATORY MASTER REMOTE CONTROL ADDITION

After power-up, you MUST program the system to respond to the Master Remote Control
used by that dealership. To do so, get one of the master remotes used at that dealership (all
master remotes at a dealership are the same code) and do the following:
1. Turn the ignition on.
2. Toggle the valet switch (located behind the LED assembly) in the following manner:
a. Left, left, right, then press and hold to the left.
b. After 3 seconds of holding to the left, you'll hear a horn beep.
c. Right once, then wait 2 seconds for the horn beep.
d. Left once (one beep), then press the LOCK button on the master remote (two beeps).
3. Turn the ignition off (3 beeps).
Delayed or dimming courtesy lights interfere with remote arming. If the delay is more than 5
seconds, turn on the Delayed Courtesy Lights feature noted on pages 9-10.
REMOTE FUNCTIONS
Function Icon remote
Arm & lock
Disarm & unlock
Trunk release
Panic
(repeated honks)
HOLD:
Locate
(short beep)
Remote valet mode
✱
Remote engine start
AutoStart/SafeStart
Window open/vent
1. With the ignition OFF, press and hold the valet switch (at the rear of the LED assembly)
to the right.
2. Use the remote control to lock, then unlock, then release the valet switch.
3. The LED will flash 2–7 times, pause, then flash 2–7 times, etc.
4. Refer to the following chart. The first set of flashes was the most recently activated trigger
or sensor. The next is the second most recent, and so on up to as many as the last eight.
CliffNet Wizard PRO provides an on-screen written report of these activations.
LED flashes
2 flashes
4 flashes
5 flashes
6 flashes
7 flashes An attempt was made to turn on the ignition while the system was armed

Delayed Courtesy Lights

Remote Control Operation

Word remote
Lock
UnLock
Opt
✱
Panic
HOLD:
Panic
Opt + UnLock
+
Lock + UnLock
+
+ Panic + Lock
+
Panic + Opt
✱

Eight-Event TotalRecall

Trigger/sensor indication
Optional Sensor
Door trigger
Trunk trigger
Hood trigger (if IntelliStart 4 is installed)
7