Table of Contents
Advertisement
Figure 5b
CFM158
CFM158
R-CFLR Gas Supply Connection
Connect remote (GWSK or MRC 1, 2, 3) wires
4/3/01 sta
to ON/OFF/RS switch. (Fig. 6) If the MRC
(remote) is used, the receiver can be placed
to the front right of the gas valve to ensure
safe operation.
1) Open the bag of Silica Sand and spread
it evenly across the Burner Pan, to the top,
as shown in Figure 7. You may overflow the
front and sides of the pan to cover the entire
pan and connecting hardware. Note: Sand is
for use with Natural Gas ONLY! Vermiculite
or Lava Rock must be used in place of Sand
for Propane Gas. Refer to Propane Conversion
Kit Manual for details.
2) Next, open the bag of Glowing Embers
and place them on top of the Silica Sand,
evenly across the Burner Pan. Be sure to
separate the Glowing Embers into very
small pieces before placing them onto
the Silica Sand.
20003903
Remote Installation
Figure 6
Adding Pan Material
Figure 7
TP
TH
TH/TP
LG188
AGA pilot wiring
Glowing
Embers
Silica Sand
Glowing
Embers
Lava Rock
7
Advertisement
Table of Contents
