Programming; Programmable Settings - Panasonic KX-TG6461NZ Operating Instructions Manual

TG6461NZ(e).book Page 21 Friday, May 15, 2009 9:33 AM

Programmable settings

You can customise the unit by programming the following features using the base unit or handset.
Programming by scrolling through the display menus
= Base unit / Y Handset
1
8 (middle soft key)
2
Press {V} or {^} to select the desired main menu. i M
3
Press {V} or {^} to select the desired item in sub-menu 1. i M
L In some cases, you may need to select from sub-menu 2. i M
4
Press {V} or {^} to select the desired setting. i M
L This step may vary depending on the feature being programmed.
L To exit the operation, press {EXIT} on the base unit or {ih} on the handset.
Note:
L In the following table, < > indicates the default settings.
L The current item or setting is highlighted on the display.
Base unit
Main menu
Caller List
W
Answer System
s
Ringer Setup
(
Base Unit Setup
>
*2
Caller Barred
7
*1 When the ringer volume is turned off, ~ is displayed and the base unit does not ring for outside calls.
However even when the ringer volume is set to off, the base unit rings at the low level for intercom calls
(page 36).
*2 If you program this setting using the base unit, you do not need to program the same item using a
handset.
Sub-menu 1
–
Call Screening
<On>
*1
Ringer Volume
<Maximum>
Ringtone
<Ringtone 1>
Display Setup
–

Programming

Sub-menu 2
–
–
–
–
Language
<English>
Contrast
<Level 3>
–
Page
28
30
15
–
12
–
–
21