Connecting The Cable - Fujitsu ScanPartner 620C User Manual

2.7 CONNECTING THE CABLE

i). Turning the Power Off
Depress the side marked " O" to turn the power off.
Connect the power cable and SCSI signal cable as shown in Figure 2-8 and Figure 2-9.
ii). Turning the Power On
Depress the side marked " I" to turn the power on. The POWER LED will light. If not, please check
the power source.
iii). SCSI Termination
The Fujitsu ScanPartner 620C comes complete with a built-in SCSI terminator. If the Scanner is
the last device in a SCSI chain, the Terminator should be switched ON. If the scanner is not the
last device, the Terminator should be OFF. The Terminator ON/OFF switch is located on the
back of the scanner, to the left of the SCSI cable connectors.
Host PC
Term.
Host PC
Term.
Scanner
(Terminator Off)
Scanner
(Terminator On)
2-10
SCSI Device
Term.