Connecting The Usb Cable - Fujitsu ScanSnap S500 Operator's Manual

■ Connecting the USB Cable

Connect the USB cable as shown below.
•
ATTENTION
•
•
Operation
1. Remove the seal on the rear side of ScanSnap.
2. Insert the USB cable into the USB connector of ScanSnap and plug the other end of
the cable into the USB port on your personal computer.
Insert firmly the USB-cable as far as it can go into the connector.
Use only the USB cable supplied with the Scanner. The operation with a com-
mercially available USB cable is not guaranteed.
When connecting to a USB hub, be sure to connect the scanner to the hub
nearest your personal computer (first stage). If you connect it to a USB hub
from the second stage onwards, ScanSnap may not function correctly.
If you connect the scanner with USB 2.0, it is required that the USB port and
the Hub are compliant with USB 2.0. The scanning speed may slow down
when you connect the scanner with USB 1.1. If your computer has the USB
2.0 compatible port, use it.
USB cable
Seal
2.2 Connecting ScanSnap to your PC
DC 16V
USB cable
ScanSnap S500 Operator's Guide
2
23