Connecting The Usb Cable - Fujitsu S510 Operator's Manual

■ Connecting the USB Cable

Connect the USB cable as shown below.
•
ATTENTION
•
•
Operation
1. Remove the seal on the back side of the ScanSnap.
2. Connect the USB cable to the USB connector on the ScanSnap, and the other end of
the USB cable into the USB port on your personal computer.
Insert the USB cable into the connector all the way to the end.
Use only the USB cable supplied with the Scanner.
When connecting to a USB hub, be sure to connect the ScanSnap to the hub
pluged into the personal computer (first stage). If you connect it to a USB hub
connected to another USB hub (second stage), the ScanSnap may not
function correctly.
If you connect the ScanSnap with USB 2.0, it is required that the USB port and
the Hub be compliant with USB 2.0. The scanning speed may slow down
when you connect the ScanSnap with USB 1.1. If your computer has the USB
2.0 compatible port, use it.
USB cable
Seal
2.2 Connecting the ScanSnap to your PC
DC 16V
USB cable
ScanSnap S510 Operator's Guide
2
23