Connecting The Cable - Fujitsu ScanPartner 600C User Manual

2.7

Connecting the Cable

i) Turning the Power Off
The Power Switch is located on the right hand side of the Scanner.
Depress the side marked "O" to turn the power off.
ii) Turning the Power On
Depress the side marked " " to turn the power on. The POWER LED will light. If not, please check
the power source.
iii) Connecting the Power Cable and SCSI Signal Cables
Connect the power cable and SCSI signal cables as shown in Figure 2-8.
vi) SCSI Termination
The Fujitsu ScanPartner 600C comes complete with a built in SCSI terminator. If the Scanner is the
last device in a SCSI chain the terminator should be switched on. If the Scanner is not the last device
the terminator should be switched off. The terminator on/off switch is located on the back of the
Scanner, to the left of the SCSI cable connectors.
HOST
TERM.
TERM.
PC
HOST
PC
SCANNER
(TERMINATOR OFF)
OR
SCANNER
(TERMINATOR ON)
13
SCSI DEVICE
TERM.