Nilfisk-ALTO E130.1 Instruction Manual page 9

5.2 Typical fi elds of application
Below you will fi nd a description of a lot of cleaning tasks which can be solved by a pressure washer
from Nilfi sk-ALTO in association with accessories and detergents.
Task Accessories 'Click
& Clean'
Car Car nozzle,
auto brush,
underchassis
nozzle,
Foam sprayer,
Car Combi Cleaner
Rims, alu- Rim brush,
minium auto nozzle,
atomizer,
Alu Cleaner
Flag- Powerspeed
stones, nozzle,
concrete Stone & Wood
fl oors and Cleaner,
other hard Patio Cleaner
surfaces
Garden Wood Cleaner
furniture, Garden brush
wood
Brickwork, Powerspeed
Wood nozzle,
work Stone & Wood
Cleaner,
Patio Cleaner
Gutter Underchassis spray
lance
Cleaning Tube cleaner
of drain
pipes, out-
lets, down
pipes etc.
Rust, paint Water/sandblasting
equipment
®
Green- Tornado
house
brush, Stone &
Wood Cleaner
Cleaning method
1. Apply Car Combi Cleaner with the foam sprayer. Always
start from the bottom and work upwards. Let Car Combi
Cleaner act for at least 5 min.
2. Wash the car with the car nozzle, which has been optimized for
quick and gentle cleaning of enamelled surfaces (the jet is wider
and not so sharp). Start at the front of the car and work back-
wards to avoid water from penetrating by the door mouldings.
3. Use the brush for removal of traffi c fi lm which is not removed by the
nozzle. If the car is very dirty, apply Car Combi Clean er again.
4. Attach the undercarriage nozzle and clean undercarriage and
wheel arches.
5. Remove water from the surface of the car with the scraper
on the car brush. Make sure that all grains of sand etc. have
been removed before using the scraper. Wipe with a wash lea-
ther where the scraper cannot reach.
Apply Alu Cleaner with an automizer. Let it act for approx.
5 min. and wash with the rim brush. For steel rims, use Car Com-
bi Cleaner. Use the foam sprayer and wash with rim brush.
Be careful! The high pressure jet may damage the tyres.
®
Wash towards outlets or the like. On surfaces with moss or
algae you may start by applying Stone & Wood Cleaner with
the foam sprayer. Wash before the soap dries. Another
more effective and quicker method is to use the Patio
Cleaner. Thus you will also avoid splashes.
Apply Wood Cleaner and wash before the soap dries.
NOTE: Use the garden brush to clean off the dirt.
®
Same method as for fl agstones, but be careful - bad joints and
wood may be damaged by high pressure. You may choose only
to use the Tornado
the quality of the joints and the wood. Patio Cleaner can also be
used on vertical surfaces.
Wash the gutter with the nozzle. Always wash towards
downpipes. Beware not to spray under the roofi ng.
Push the tube cleaner approx. ½ m (to mark) into a tube or drain
and activate the trigger of the spray handle. The nozzle opening
turning backwards will pull the cleaner through the tube. The
nozzle will break down the „plug" and fl ush the dirt backwards.
Mount the water/sand blasting equipment and rust and paint
is effi ciently and quickly removed. Beware not to damage the
surface to be sandblasted.
PR nozzle Wash with high pressure and maybe a brush. You may use Stone
& Wood Cleaner to remove moss and algae.
®
nozzle. Adjust the distance (pressure) to
EN
9