Subscribe to Our Youtube Channel
Related Manuals for Rosco PF-1000
Summary of Contents for Rosco PF-1000
-
Page 1: Operating Instructions
PF-1000 FOG MACHINE Operating Instructions Rosco Laboratories, Inc. 52 Harbor View Avenue, Stamford, CT 06902, USA (800) ROSCONY, (203) 708-8900, Fax: (203) 708-8919 email: info@rosco.com... -
Page 2: Table Of Contents
The ROSCO PF-1000 Fog Machine is a thermal aerosol generator designed for low fog output. It is part of a system, the other basic component being the full line of Rosco fog fluids, and they should always be used together. These unique fluid formulations are safe when used according to instructions. -
Page 3: Important Safeguards
To do so with any high-amperage device is to assume substantial risk. Rosco strongly recommends against 5. In any facility, the fog concentration should be controlled. The fog should never mask emergency exits, safety signs, staircases or other safety constructions. -
Page 4: How The Machine Works
NOTE: The terms “fog” and “smoke” are used interchangeable. However the ROSCO PF- 1000 does not produce smoke, but a mist or aerosol. -
Page 5: Components
Place the other end of the tube into a bottle of one the Rosco fog fluids. 4. AIR INPUT (Optional) The PF-1000 comes with an Air Input Kit which can be used for fog effects or, more importantly, to clean the machine using compressed air. To install the Air Input Kit, remove the small brass screw plug on the back of the Head Assembly. -
Page 6: Operating Instructions
15’ fluid tube may be empty and it will take a some time to fill it with fluid. 4. REMOTE CONTROL OPTIONS The PF-1000 has a variety of remote control options including show control. To use any of the remote control options, the LOCAL/REMOTE switch must be moved to the REMOTE position. - Page 7 To operate the air solenoid locally, push the SOLENOID button in the Control Module. To opearte the air solenoid remotely, connect a switch through the supplied 7-Pin Male XLR Connector using pins 2& 7. PAGE 6 ROSCO PF-1000 FOG MACHINE www.rosco.com...
-
Page 8: Do's And Don'ts
Read the entire manual before operating the machine and pay particular attention to all CAUTIONS AND WARNINGS. Use ONLY Rosco manufactured fog fluids. Use an extension cord which is properly rated for voltage, current and length and which is free from nicks or other signs of wear. -
Page 9: Maintenance
MAINTENANCE 1. The main fuse of the ROSCO PF-1000 Fog Machine is located in the Control Module. NOTE: Be sure to check the specifications when replacing any fuses. WARNING: DISCONNECT THE ROSCO PF-1000 FROM POWER BEFORE CHECKING OR REPLACING THE FUSE. FAILURE TO DO SO COULD BE HAZARDOUS AND RESULT IN AN ELECTRICAL SHOCK. -
Page 10: Offices
ROSCO OFFICES WORLDWIDE If the machine fails and repairs are required, call or write the nearest Rosco office (listed below) or your local Rosco dealer. UNITED STATES UNITED KINGDOM World Headquarters Roscolab, Ltd. Rosco Laboratories, Inc. Blanchard Works 52 Harbor View Avenue... -
Page 11: Storage And Shipment
During the warranty period, machines will be repaired or replaced at the option of Rosco. The warranty does not extend to any parts of the ROSCO PF-1000 that have been subject to misuse or accident. Neither does the warranty cover any machine that has been opened, modified or repaired other than by Rosco or its designated repair station. -
Page 12: Technical Specifications
SUPER REMOTE CONTROL Allows fog to be turned on and off, volume control, and cycling of machine to be operated from remote location. DMX INTERFACE Allows machine to be operated from lighting control console. PAGE 11 ROSCO PF-1000 FOG MACHINE www.rosco.com...
Need help?
Do you have a question about the PF-1000 and is the answer not in the manual?
Questions and answers