Inspection - Yamaha YB50 Service Manual

HANDLEBAR AND STEERING
8. Remove:
s WARNING
s
Support the steering axle so that it does
not fall.
9. Remove:

INSPECTION

1. Wash the bearing and race with solvent.
2. Inspect:
Steps for replacing the bearing race:
• Remove steering bearing races using a long
rod
• Remove the bearing race from the shaft
using a chisel
shown.
• Install the new mudguard and the guides.
6-21
• Upper ring nut
Ring nut wrench for steering
90890-01403
• Lock washer
• Central ring nut
• Rubber washer
• Lower ring nut
• Bearing cover
• Lower bracket
• Bearings
• Bearing race
Pitted/Damage
and the hammer as shown.
and the hammer as
CHAS
Change